MaxMidnight

Follow the attached fault finding algorithm.

You would remove some of the foam padding but that will have three consequences. i) Less foam = less support for your backside which may...

The rear ride height is fixed by the length of the shock absorbers although reducing the pre-load might allow it to settle down a bit...

The blue wire on the OE loom is the feed for the illumination and black is earth. The white/ green is for the reed switch with is part...

If not already obtained I suggest you acquire a copy of the Service Manual which explains the operation of the ignition/ timing. There...

As far as I know he no longer makes them, I haven't seen him on V Max Chat for some years and the last time he posted was 2016. I've...

IMO that is unlikely to be the issue. Unless there is excessive axial movement a small side to side play is probably acceptable. When...

Try wrapping some PTFE tape around the thread and up on to the bottom of the hex.

Balancing the carbs is to ensure a similar air flow (or restriction) in the venturi. The mixture screws set the volume passing through...

You are saying that the motor opens and closes? When it opens are the V Boost butterflies fully open? If so then IMO the motor is...

As it will open then that would imply that the motor is OK; I assume closing is achieved by reversing the polarity? Have you checked...

I have seen pictures of them in the past but IMO completely spoil the lines of the bike and add weight high up. IMO the better solution...

If it is the OE hose then yes. I work on the principle that if it ain't broke don't fix it. I take Mr Radioguylogs point but doing the...

If the condition is still present try gently loosening the bleed nipple and see if any fluid is ejected. If so that would suggest that...

Like any transaction it is worth what the buyer wants to pay and I suspect with that sort of mileage not a lot as it would most likely...