I wear a Harley Davidson perforated leather jacket with elbow and shoulder armor, armored gloves, helmet and harness boots for my highway work commute.
I have some new boots that are meant to wear all day but still breaking them in. When the weather is cooler I have vented leather jacket with...
I have Progressive 444s stock height with preload set pretty close to their recommendation. Progressive springs in the front and their 1 inch lowering springs and ricor intiminators and Sean Morleys adjustable preload fork caps. I just need to cut the spacer a bit more to take some preload out...
I used to have the DD but switched to a Barnett type coil spring plate and instead of the heavy duty springs went the next size up and used their 99lb springs. Works fine for me
Bungs were already in the aftermarket headers when I got it. I used this
Innovate Motorsports 3806 LM-2 Digital Air/Fuel Ratio Wideband Meter (1 O2 Sensor) and OBD-II Scan Tool Amazon.com: Innovate Motorsports 3806 LM-2 Digital Air/Fuel Ratio Wideband Meter (1 O2 Sensor) and OBD-II Scan Tool ...
I got my bike from Garrett here on the forum and he dyno tuned it. I didn't measure the screws correctly when I took the carbs apart it clean due to rust in the tank. Never could get it right after that. Turns out cops installed pushed a pin out so three cylinders. By then I had decided to do...
I have bungs in all of my pipes. I used a wideband to get as close to 14.7 as I could then turned a bit leaner later. I since realized I had too large a spark gap for the COPS system. Fixed that now and haven't gone back to check the O2. Bike has been running great this year though.
I purchased this off the forum from Garrett (spelling?) It was a great bike to start with due to the mods he had done. Of course the mod monkey got a hold of me and I've done more.
How fast are you cruising on the highway and how lean is your idle setting? Best I’ve gotten is 35mpg with Sean’s kit but I may still need to tweak some things. I cruise at 80-90 mph at times