Recent content by Baco 83

Luckily it is just the seat cover. I talked to Sean a few months ago about a seat when I bought the brake lines from him. I'm just not sure which way I want to go yet. I'll probably just get a seat cover off ebay and save the money for a new boost controller

It's been a hell of a battle getting this thing road ready. Only a few small thing left to do but it is rideable now

Do you still have the vboost controller? And how much?

Absolutely. I'm replacing my break lines today and wiring in all my lights. With any luck I'll be on the road soon

You don't have to apologize it was a good reminder. Lol. I'm in smithfield now off 44 not far from Newport creamery. I did remove the jet block, removed and cleaned all the emoltion tunes. And cleaned all the air pilot jets. The fuel filter is new. The stock filter was replaced with a k&n...

I did have all the mix screws at 2 1/2. I also turned them up to 3. Just trying to figure out exactly what is causing it. None of the settings made a difference as far as the bike bogging

I'd say get a good one if that's the issue. I bought a cheap one off Amazon and was not able to use the factory mounting point

I have it closed because the vboost controller is only opening not closing. So just for tuning purposes until I get a new controller

I feel your pain. I bought mine in January and so far electrical wise the bike wasn't charging, had a bad fuel pump, and a bad vboost controller.

No. Those don't come on until the switch is flipped to run. I also had an issue blowing my ignition fuse. Come to fine out it was my fuel pump shorted internally

Having issues with the bike going down the road. Sitting in the driveway it starts and runs on and off choke. I can even bring it through the rev range. Once I start riding it, it boggs down around 3500 rpm. Vboost is disconnected and plates are closed. I've removed and cleaned the...

I cut a small amount out to test the connections to the wires. But when I took the board out of the case the bottom hole in the coating looked like the top hole. I am going to try tomorrow to reflow one of the connections. My main concern is the bridging of the solider points in the...

Pulled my vboost controller apart and found some of the coating on the bottom side melted along with what looks like some solider points the melted together. Does anyone have a picture of the bottom side of the circuit board so I can attempt to clean this one up.

New handle bars