Recent content by Firerider

Looks like the new (available to order) PN# for the shim removal tool from Yamaha is 35-3462. This is available from your Canadian Yamaha Dealer for just (WOW) $179 CDN. It is also avail. on line for $56 US in either #04105 or YM-33961 #'s and is avail. in Can. aftermarket for $79.95 + $20...

I have been looking to purchase a valve shim removal tool for valve adjustments on my 85 V-Max. I am finding several different numbers for what appears to be the same tool. The numbers are 04105, 04105 YM-33961, YM 04105, and 35-3462. While checking online the main compatible numbers stamped on...

I like the option that THMAX98 used. Make sure you index the rubber to the slide, as removed. Did anyone else try the reversed butter knife option to press the new rubbers in. Worked great for me. No cutting or gluing. Just go easy and don't twist the knife blade and use lots of lube... Video is...

Looking for a pair of stock head pipes for my 85 . Preferably in Canada (shipping) but open to any.

Thanks Bill. I pulled the header pipe off and it is cracked about 1-2 inches down the inner pipe. I'll be looking for a replacement header pipe. I was thinking of using JB Weld to temporarily patch it and see if the noise goes away. Thanks again...

Have the same problem with my programmable controller. Worked ok for 1st few months then started acting up. Had it replaced and same thing happened. I am now running my old stock controller after taking it apart and re soldering main circuit board wires. Seems to be working ok this season. If...

The bike is listed in the site registry and is an early (0339) number. Don't see anything regarding for USA market on the decal but it does have a small round CANADA TRASNPORT decal above the steering head decal.

Thanks. I'll check the pipe theory tomorrow and see if I can figure out the video thing as well.

Started hearing a metallic rubbing sound from engine. Like something rubbing against a case cover or ?. Thought it may be the water pump but the noise is coming from the other side. Does not knock when started but after running a few minutes starts low and gets louder as it runs. If I blip the...

Speedy and healthy recovery, John. I'm still enjoying my Sportsmax seat. All the best to you and yours.

When I was finally able to find a nice clean V-Max (85, ten years ago) I thought I would baby my baby with the good (synthetic) stuff. Two weeks later the starter clutch crapped out. Coincidence, maybe, but I haven't used it since and have had no further issues. I know this topic has been...

Yes, this is a replacement for the old controller and actually fits back in the original controllers case. James claims they are built with better components and they do come with a guarantee and they are adjustable above 2000rpm in 250rpm increments. You can check them out at micromachines.ca

Just received adjustable V Boost Controller from James @ Micro Machines. Can't wait for weather to pick up and I'll give her a try and let you know how it 's working. Anybody else out there used one of these. Tried soldering my old one but it only worked (when it felt like it) for a few...

Don't forget to put a long bolt in the center of the fly wheel. Keep it backed out an inch or so. When that M/F finally pops off, the bolt will keep it from flying off the shaft and across the room, which is more exciting but not too safe. Mine took me almost a week before I got mad enough to...

MERRY CHRISTMAS to all, and all the best in the NEW YEAR Many Thanks as well. Haven't been too involved directly this year but keep updated (almost daily) as much as possible. Always good advice or at least a good story to be heard. A resolution for 2012 ?? Thanks again to all.