I went ahead and did the entire double D conversion and now it goes into N just fine. Only thing is now I hear a chatter coming from the clutch that gets quiet when I pull in the clutch lever. Maybe it's just me and Maybe it had a chatter before. Not too loud. I put a screwdriver to my ear to...
According to the diagram I have the seat plate and spring cushion and half disc. Do they all go back in? There was never that retaining spring in front of last steelie. I'm stumped
Dman999. Are you speaking of the ring I have out or the one I can't remove? They look the same. I don't see a wire retainer. Previous owner must have removed. If you look at the second pic there are 2 rings that look similar. One on and one off the bike. I don't see anything else. Bike shifted...
That's how I have it. Pressure plate then that small ring with 1st spring on top with second spring directly on top of the first then the retainer. Was fine before I added second spring. I'm stumped
Just did the double D clutch upgrade. I left the half clutch in the back so I'd have some slipping not to break any parts. But it won't go into Nuetral when the bike is running. When the bike is off it goes into N without an issue. Had it apart to check 3 times now and I can't figure it out for...
Just did the double D clutch upgrade. I left the half clutch in the back so I'd have some slipping not to break any parts. But it won't go into Nuetral when the bike is running. When the bike is off it goes into N without an issue. Had it apart to check 3 times now and I can't figure it out for...