Recent content by maxspeed6

Sean, whats the difference between the single tube and the double ? The double is stiffer i presume ?

you also have the GSR-S1000 this years that is gonna be a beast ... it's a GSX-R but in steet fighter mode

yes, i will do it in the futur if i need to adjust my a/f ... this adjustment don't effect the mixture in rolling condition, correct ? My adjustment now is 3 1/2 turns out, its far from the 2 1/2 from the service manual but is like that since i have the bike and the bike runs good.

Thanks all Today i cheked the ohming of the secondary of all ignition coil and all is on the spec. I do the peashooter and the shotgun cleaning technic and put some STP cleaning ( like seafoam ) on the tank with fresh gas and roll it for 35 kms without any bog. I think that ive found...

Thanks all for the tips ... i dont have dremel but you think that drill a little hole on the screw and insert a hallen key in the hole will do the job ? Or its better to find a dremel ? And i can do the peashooter / shotgun without screw out the a/f screws ? If not, i will remove the carb off...

Hi guys, to start please excuse my bad english level So i have a 2004 max with 52k kms. I have it since 3 years now and it always runs great with a powerfull acceleration. Since 2 week, i have an issue with my bike. It's intermittent. The bike as no more power (like 50% less power) and...

and what's the benefice of putting a 170-80-15 in rear apart which is cheaper ??

Hi everyone, i need to replace my rear tire on the max. I actually ride with a Shinko 230. I search to replace it and i find 3 tires wich it seems pretty good. 1- michelin commander II 2- Metzeler ME880 or ME888 ( what is the difference?) 3- Avon Venom AM42 These 3 tires turn in the same...

http://www.youtube.com/watch?v=yKni9g6ZbFE

We can feel the difference on the bike with the brace ? And when do you think you will have the brace ?

thank you guys for the comments ... this bike is a monster. It's my fun to burn at every stoplight ;) For those who want to know where i stick my gopro, it's on the gas tank under the side panel

My tire was about to be over, so here it's the end ;) http://www.youtube.com/watch?v=yKni9g6ZbFE

I tighten my steering bearing today but i forget to loosen the Stem nut and the hallen bolt on the triple tree. These steps are important in the procedure or not ?

it's better to change the seal in same time when you change the fork springs ??

I have a question about this. If i have a 2004 ( with the redesigned segment) I can have some miss shift sometimes with this segment or it's just a bad shifting move or a bad transmission ?