Recent content by Pissed off Veteran

Get rid of that windshield.

Generator cover holds the plate in place, I see now.

Yes pictures, Please. Thank you, I know the 3 screws, just want to clarify everything before I start attaching stator and pick up coils. who ever had the bike before me had the plate#9 on one of the gears there in the case. What size allen heads you order?

Alright so 9 goes on top of 8 and Lays there like in picture, nothing holding it in during installation?

8, 9 and 15 were not installed on stator when I disassemble.

Thanks Cap, Next question, how and where to install shaft, part#15?

Not really sure where these go. Is it number 9 on schematic. I bought number 8 on schematic because it was missing when I removed stator and figured I better buy 9 and 15 also . When I removed generator case things kinda fell into case and 9 was one of them.Top one is the old.

Mine is a 2021 rated at 165HP and about the same for torque. I do have aftermarket exhaust. I know when I finish riding the Vmax and jump on the Rocket there is no comparison. But at the same time I think my Vmax is not running full power and that's why it's in pieces. Just finished rebuilding...

Lmao, I could not imagine it being turbo. This bike is a beast. People say the 1200 vmax will keep up with the Rocket, no F'ing way, I know from experience. Takes about all my arm strength to hold on when she is wide open. She is heavy though and you have the massive fuel tank between your legs...

Definitely get the Rocket. I love mine. Extremely fast, smooth as a cadillac..

Yes, believe it was part#36 from carb schematic Medic. The o-rings and gaskets fit good from K&L. Still have 3 carbs to go yet. OH almost forgot the rubber caps on jet block, they just fall out, sitting here laughing to myself.

I ordered a new one from Partzilla. Punching them in and out a few time kinda mushroomed where needle goes. The ones from partzilla should be good, correct?

I'm rebuilding carbs for my 88 vmax. I purchased the K&L 18-2879 carb kit. I tried replacing float needle and seat. The new needle valve seat pushes right out with a little pressure after I install it with a punch making sure it's seated. So I break out the micrometer and measure the width of...

Lmao, same here.

Hope it comes with directions.