Recent content by wkdenton

VMAX  Forum

Help Support VMAX Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. W

    service manual/repair manual

    I have a Yamaha tech manual if you still want one
  2. W

    starter clutch

    Please PM me with the flywheel puller picture and dimensions? Thanks, I'm preparing to replace a starter clutch on a VStar 1100 and it has the exact same design as the Max.
  3. W

    Rte. 6

    Rte 6 is one of my favorite PA roads, last time I rode it was on my way to Kinzua Bridge.
  4. W

    attacking my slave cylinder, quick question

    Re: Slave cylinder, new question, destroyed pushrod oil seal... In a pinch you can also reuse plain copper sealing (crush) washers by annealing them. Simply heat to cherry red with a propane torch, then quench with cold water and reuse. I routinely use this technique with copper (but never...
  5. W

    Replacing Carb Diaphragms

    +1 ^^
  6. W

    Valve adjustment shims

    Just found this year-old string while searching for valve adjust tool loaner. FWIW, my CB-X, like many other DOHC Hondas from the 80's, uses 25mm shims. When bought new, they're about 1/2 the price of VMax shims. I usually buy mine used at a semi-local dealer in South Jersey on an exchange...
  7. W

    Ethanol and fuel stabilizer

    I would not do it. All the anecdotal coments about significant increases in mileage are not supported by thermodynamics, especially at the low percentages of acetone (aka dimethyl ketone) that are being added. Also, and imho much more importantly, acetone is a very aggressive solvent that is...
  8. W

    Ethanol and fuel stabilizer

    My bottle of StaBil has a notice that reads, "Product can be used for up to two (2) years after the bottle has been opened".
  9. W

    Is it just me , or you guy's too ?

    Try a few of these, no one will touch your lid. http://www.birdsplats.com/2012/04/02/like-kick-me-but-better/
  10. W

    Am I the only one with a Bell?

    I have a bell on my '96 GPz1100 that was given to me by a rider friend. I sure wish someone would give me another for the '99 Max, I feel nekid w/o one!
  11. W

    Brake Pads

    http://www.boats.net/parts/detail/yamaha/outboard/Y-26H-W0045-11-00.html
  12. W

    New master cylinder

    Really? What seemed to be the issue with cleaning the hole?
  13. W

    Anyone have any method of removing bolts that have locktight

    ^^ +1 , in addition, heat may also warp the cover, rendering it worthless. Another little known fact about thread lockers is that they inhibit (galvanic) corrosion of dissimilar metals, e.g. steel bolts threaded into aluminum cases which, counterintuitively, makes them easier to remove (with...
  14. W

    Ethanol and fuel stabilizer

    All other things being equal, yes.
  15. W

    Ethanol and fuel stabilizer

    Unfortunately, no.
Back
Top