Search results

I love my vmax and own a 82 Harley shovelhead FXR it's a great bike, Most problems I have seen are due to owner ability to fix things correctly or no repairs at all , sound familiar? I enjoy the old iron lots of character.

I priced the 2 in baffle yes its pricy so I built one from an old cherry bomb muffler and some stainless perforated tubing from LA Choppers. I sawed off the ends of the muffler trimed them to fit in the can. Then cut the tubing to length tack welded it to the ends wrapped it with packing sounds...

Yep Hayabusa brakes work great. I got parts from one2dmax made a huge difference, my bike is a 85 also add stainless hoses.

I just looked in the service manual on page 3-66 that is for sure the oil pump drive gear. It may have locked because for any number of reasons most likely a assembly mistake a very expensive mistake. I would tear it down and check everything. You may be able to salvage the heads and cams and...

Congrats on the bike, those FCRs are great carbs. I run the PCW 39mm with a 30mm bell and UNI filters lightly oiled. The carbs need clean fuel and a good fuel filter. I run threw the gears a little longer than with the stock carbs, they will bog, just treat it like a dirt bike! You will need to...

Mine was popping like crazy last week, yep leaky exhaust gasket. and loose pipe to.

I bought a 95 Yamaha wr250 and rebuilt the top and bottom end for 800.00. It needed the crank pin, rod and piston along with the lower end bearings and seals replaced. The bike is a screamer for sure. I would look into what a complete engine rebuild will cost on the bike you are looking at. I...

I removed the pipes and had two rings made up and welded around the two places where the rear pipes go in. This made for better support and no more cracking of the thin metal. I also use the high temp sealant it helps quite a bit. Hope this helps.

You will like them I just came in from the shop after doing the conversion on my 85. They look very trick compared to the old brakes.:punk:

Almost sounds like a p.o installed the wrong springs and covered up that by adding more air and when she went she dropped way lower than expected!

Glad your Dad is going to be ok. If I can still walk when I am 70 I will be lucky

I installed the double d per PCW in my max back in the early 90s. It has been good ever sense, even running synthetic oil. With the stock clutch and syn it fried.

Looks good I got Seans adapters and just need the time to get er done.

Ok your pump sounds like it is good. I would at the very least put new plugs in it. I have a 85 and it does the backfire deal and won,t start when the plugs go to crap. Then like was said check for voltage at the tcu.

Is the fuel pump running constantly or not stopping? If so you may have a rubber valve out of place in the pump making it not build pressure. If that is the case there is thread about reparing it. Just search on fuel pump.

Great mod I ordered the blue l.e.ds a few days ago. They arrived today and the install was simple and the results are great. thanks to all:punk:

Glad your alright man, sue the dingbat broad. I drive all over central Illinois for my job, and damn near every woman I see is flapping her mouth on a cell phone, men to. I have one myself but think they should be banned for use on public roads.

Thanks for the replys My 85 bike has always had a painted oil pan. The 98 has a stock pan, just plain I didn't know if Yamaha painted them or not.

Howdy men I looked at a 98 blacked out vmax and noticed the oil pan was plain aluminum. Did this come from the factory this way or could the pan be new or a replacement for whatever reason? thanx

I bought there flatsides back in the early nineties and have been very happy with the performance and support. Just run filters on them if you ride on the street.