Sharky
Well-Known Member
Ok..so problem is wheel is 10mm to left which although considered normal on a max seems very odd to my mind.
So after researching this and investigating the wheel I've worked out the following.
Swingarm diameter where shaft goes is 61mm OD.
Allowing even 3mm wall this leaves 55mm.
Shaft is 17mm diameter thus 38mm/2 gives 19mm clearance either side of shaft.
On the wheel (3 piece) I can remove 10mm of ali on the shaft side hub piece to move the wheel to the left thus centreing it.
Notch the arm 10mm to match this and I have clearance for a 190 with a central wheel.
Any points I've overlooked ?
So after researching this and investigating the wheel I've worked out the following.
Swingarm diameter where shaft goes is 61mm OD.
Allowing even 3mm wall this leaves 55mm.
Shaft is 17mm diameter thus 38mm/2 gives 19mm clearance either side of shaft.
On the wheel (3 piece) I can remove 10mm of ali on the shaft side hub piece to move the wheel to the left thus centreing it.
Notch the arm 10mm to match this and I have clearance for a 190 with a central wheel.
Any points I've overlooked ?