Slave Cylinder Rebuild

VMAX  Forum

Help Support VMAX Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

jake32

New Member
Joined
Jul 30, 2013
Messages
3
Reaction score
0
Location
Minneapolis
Has anybody done a slave cylinder rebuild? I just finished replacing my clutch plates as my clutch has been slipping, now I need to address the slave cylinder (its been leaking and I have no clutch) Any advice on how to do it or a helpful website would be much appreciated! Thanks
 
Once you get it off (that's the worst part) use your air compressor to blow the rubber bits out so you don't have to fight with them.

Also, don't use a ball-end Allen wrench on those bolts. You'll lose the bit and have more work than you want.

Sent from my Galaxy Nexus using Tapatalk 4
 
It's pretty self explanatory once you get it apart, order the inner and outer seals beforehand, the rest is just cleaning it up.

Run a search, I'm sure there's some slave rebuild info here on the forum.
 

Latest posts

Back
Top