Sharky
Well-Known Member
Just wanted to check the size of pipe used by marks etc.
The st/st I have is 38mm OD, 1.2mm wall...
The st/st I have is 38mm OD, 1.2mm wall...
Exhausts...pipe size question.
- Thread starter Sharky
- Start date
-
- Tags
- exhaustspipe question size
Help Support VMAX Forum:
Sharky
Well-Known Member
OK ..thanks mate...might look around for some larger bore mandrel bends...the stuff I used only owes me $30
Sharky
Well-Known Member
Not wanting to question ya Sean but the Kerker 4-1 and the V&H were both 38mm OD.
Might be. I don't remember since it's been awhile since i measured them. They are pretty much all the same though. If you use too large a pipe then you will lose a significant amount of torque.
Similar threads
