125

I am replacing my starter clutch ..its off but I did not use the cone on the puller and I messed up the first couple of threads on the crank nose and my bolt wouldn't start to thread. I measures the flywheel bolt threads with a gage and i'm sure it is 12m 1.25 is this correct? Also can I...

Okay, so I installed my float needle and seat. While I had everything apart, I decided to clean the the carburetors. Then I noticed something: One of the carburetor throttle butterflies is stamped with the number "130". The remaining butterflies are stamped with the number "125" . I went...

Hello people, I haven't been active for a while, but I sure have been reading various threads. I want to put a Metzler 880 170-80-15 on the rear, and run 12.5 Progressive 430 shocks. Do I have enough clearance in there for this combination. thanks Smackdown

Has anyone had this problem with this kind of mod and if so how did you remedy it? I tried cutting the stand off in 1 inch increments and due to the angle between the stand in full extention and closed it wound up too short on that final inch. Now I have to order a new sidestand. Thx again...