Recent content by bokaeser

VMAX  Forum

Help Support VMAX Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. B

    Mpg

    I'm running 147.5's with slip on exhaust and drop in K&N filter....my fuel light came on at 103 today with pretty even mix of highway and city...what do you think? Can I do better?
  2. B

    EMGO air filters without correctors?

    anyone ran these? http://cgi.ebay.com/ebaymotors/Improve-MPG-Vmax-1200-4-air-filters-breather-52_W0QQcmdZViewItemQQhashZitem1c0e988fdbQQitemZ120503963611QQptZMotorcyclesQ5fPartsQ5fAccessories
  3. B

    california model throttle valve size

    in the manual it shows the california models use a 130 throttle valve (brass butterfly) and the other states use a 125.....whats the difference? what difference would swapping from one to the other have?
  4. B

    aftermarket header diameter?

    Do all of the after market do the crossover in the rear as the stock? Thinking custom exhaust but that hard part is the crossover.
  5. B

    COPs (Mitsubishi version)

    150 miles today no issues...... as for yesterday, yes gas was running out the overflow..... no fires who's Christine?
  6. B

    aftermarket header diameter?

    Looks like the smallest section of the stock header is 1 1/4 diameter. Are the aftermarket versions of Marks, Kerker UFO all 1 1/2 inch?
  7. B

    COPs (Mitsubishi version)

    Tach started working again each time I replaced the fuse. Took it for another spin last night after i cleaned the float mechanism its running perfectly again. I was going to add the resistors but I'd like to run it again today to see if it happens with the float working properly. I'll...
  8. B

    COPs (Mitsubishi version)

    So rode about 150 miles today with the denso coils.....here's what happened. Crusing along at 85 in heavy traffic. Noticed that my throttle was not responding. Looked down at the Tach and its jumping around for about five seconds then it shut down. Got to the side of the road and noticed a...
  9. B

    COPs (Mitsubishi version)

    Denso's arrived today and worked perfectly.
  10. B

    COPs (Mitsubishi version)

    Just thought I would ad. I purchased some "03 04 05 R6 06 07 08 09 R6S YAMAHA PLUG COIL W HARNESS" on ebay. Looked great apon inspection. I messured the resistance and they all messured 0.8 ohms. I figured this was low but in installed them anyhow. On first fire up seemed ok. I noticed...
Back
Top