Recent content by brett03

Thanks Sean.

Has anyone tried Royal Purple Synthetic power steering fluid for fork oil ?

Finally some good news. Long story short, I replaced a carb that had a frozoen A/F screw. That fixed that problem but created a new one. The replacement had an air corrector installed and I didnt realize it untill now. I removed it and it runs great. I would like to Thank everyone for the help...

Ok, I'm going to try a larger main jet size next. Don't know how big to go but I guess I'll start here. Does anybody have a set of (4) 155 or 157.5 mains they want to sell?

Time for another disappointing update. Installed the Mr. Gasket fuel pump with same sputtering results.

I do not know the jet size that is in it. I will take apart again and find out. I have just recently shimmed up the needles with no change. What is the stock jet size? Where is a good place to get jets? I think I'm also going to try a different fuel pump. jfeagins had mentioned that it could...

Voltage results: off 13.03 -- Idle 13.95 -- 2000RPM and up 14.44 and steady all the way thru when it stumbles and sputters and same after.

I'm running C.O.P's and have bought 3 different sets and still same problem. Each of the times I have cleaned the carbs it has been a complete and total tear down of them including jet blocks. I will rig up something and try to check voltage while riding and let you know. Thanks.

I disabled the Vboost in open position same result. Then disabled Vboost in closed postion. Same result. Also tried A/F screws set at 2.5 turns both ways and same. Also the pump does'nt seem to run any more the usual from what I have read. I pin the throttle at 3-400RPM and it does'nt do it till...

Time for an update: I'm about at my witts end on this:bang head::bang head::bang head:. When I snap the throttle and hit 7000RPM it falls on itself. Feels like it drops a cylinder. After about 5 sec it will sometimes recover and take off. It does it when climbing thru all gears each time it hits...

Sputter has stopped and just a hesitation when I go WOT. I will keep adding Seafoam and try to put some miles on it. Damn Rain. Will let you know. Again Thanks to all for the help.

Ok, The problem started before the COP mod. I'm going to guess that the problem might have been wire connection on the AFT right coil. I reinstalled the 2 plugs I removed and checked the COP wire connections. When I started it and went to 4000 RPM to check if the slides were the same and they...

Checked wet float level. AFT right carb is just a hair below the 17mm mark. i pulled the plug on that cylinder and here is how it looks. And here is a pic of the FWD right cylinder I have also just replaced the vacuum advanced line and arrow was/is pointing up.

I have new plugs in and gap was checked. The problem started when i was riding it and now its on the center stand in nuetral. I will pick up some clear tubing tomorrow and check the wet float check. I have drained the bowls a few times and have'nt seen any debris. I have aslo ran Seafoam thru it.

Update : I have moved the Regulator/Rectifier up to the location were the aft left coil was. Ran the red wire to battery pos. & black wire from mount screw to battery neg. Never did find the 3 black wire splice. Idle is 14.33v & 2500 RPM drops to 14.23v. still no change in the way it runs.