Recent content by Doug_103

About 1.5 - 1.75 inches. The air seems a little funny for me though. With the moto forks we add air bleeders to drain any built up air pressure that builds up during riding to eliminate blowing out the seals. :ummm: And I wasn't sure if the oil level changed much since I replaced the old...

Well, I just took out the old springs and put in the new springs. I did not add or change the fork oil since the bike only has 3500 miles on it. I did remove the forks from the triple trees to do this. As for the sag, I just followed the Racetech directions with the 5/8" to 1 1/4" preload.:ummm...

Hey there everyone! Okay so I just installed Racetech 1.0 springs on my 06 Max. The first thing I noticed was that the new Racetech springs are about 3 inches shorter than the stock springs. ( But a heaver wire ) So then I cut the 22 inch aluminum spacer tube in half to 11 inches each...