Recent content by Glenfruin

No brake light is fine just broken wire in the console loom

The Three brown wires in the short tacho loom all join into one brown wire that had burnt out on mine it could be one of those three have broken , check my post how to fix neutral and tacho post on here

Hey I had this problem recently and did a post on here in the how to fix section I think but it was the brown wire in the little console that holds the tacho temp gauge etc I removed the console, it up plugs up near the steering the brown cable was broken in the short wiring loom I had to cut...

Thanks so much that’s a really simple easy to follow diagram and the link for eastern beaver is good to cheers buddy

That sounds a bit too technical for me, unless you can give me a link to the relay and a short guide how to wire it in? I understand if it’s hard to explain cheers buddy

Yes I could run wires from the battery but I would like it to turn on and off with the ignition so I don’t forget and flatten the battery

Ahh I see what you mean so an ammeter is the better option than a voltmeter, you have helped a lot with that recommendation unfortunately I have bought a voltmeter but it was less than a tenner , I will check Amazon for the ammeter this forum is valuable for this reason someone with the...

I like your suggestion about using the brown wires at the gauge cluster, and if I decided to go nearer the fuse box how would that work? Would it still be any brown wire at the fuse box? And would the negative connection just go to ground somewhere? Please excuse my ignorance about the wiring I...

Thanks so much this is valuable information you guys are great

It would be nice to see what the voltage is while riding to check it’s charging and it lets you know of a possible issues with the battery, I’ve recently done the crimp fix and regulator rewire 👍

That’s great did you wire it into the brown wires on the console or the ignition switch ? Thanks for your input

Yeah it’s a bit small doubt you can get one that siz; the one I got is about 1 inch by two inches I might stick it onto the handlebar clamp in the middle

Ok thats easy to access, I was thing it might have to be the ignition switch thanks 👍

Hi yes I’ve got the Haynes workshop manual but to be honest the wiring diagrams look complicated I did think the brown wires were live but wasn’t sure if they were live all the time thanks for clearing that up for me so any brown wire up at the yokes area will do 👍

Hi all Im going to fit a small 12volt battery gauge so I have a visible display of the battery voltage, probably on the handlebars I am wondering if anyone knows if there is a live wire I can attach it to so that when the ignition is on it comes on and goes off when the bike is turned off so it...