Recent content by MeanMax

Feel its a honor that a fellow VMaxer would come from Oklahoma, meet with people from Massachusetts and New York, And stop by street night at a drag strip where i race. Thank you Eric, Mike, Steve and Danny for stopping by! Turned my best time of the year (while rolling off the throttle 50' of...

Was BSing with the other racers when 3 VMaxs rolled in. Every one looked at me and asked if i called in reinforcements! :rofl_200:

That looks like my home track Lebanon Valley. Wish i could have seen him run before he passed away. That mush have been one scary ride

:biglaugh: Mark, Your old Max is loved and cared for. Cool to see it got a win before i got a got a hold of her :eusa_dance:

I have had my 98 Vmax for 7 years and have had some success with it in bracket racing. A very good friend of mine races a 09 Max at the same track and has taken home a couple of wins. It got me wondering. What is the winningest single Vmax? Car/Bike shows, drag races, road racing, (Not likely...

Thank you Sean. Was running out of ideas for a winter project lol. Not necessary but would be neat and fun to buid. :biglaugh:

I have been thinking about adding an oil cooler for a while, but searching for a bolt on kit has been hard to find. Found some from japan that cost an arm and a leg. I ran the idea past John at PCW but he said the coolers they use are to restrictive. (there like a radiator. Oil goes into a a...

New personal best! Have been running 10.8s to 10.7s this year but some how pulled this off last night.. 98 Vmax. UFO flat slides, PCW 1260cc with moderate head work, undercut transmission, Morleys Muscle 6" extended shaft drive swing arm, R6 front wheel. 60 foot - 1.53 1/8 mile - 6.684 mph -...

Thank you every one! And is a 98 Danny :biglaugh: Not too bad. It never handled great anyway. Just now the front sticks and the rear defiantly feels bias ply. I actually emailed Cossman about a 18 inch weld on first. but they never got back to me. Am going to get this done soon though! That...

This is my 99 R6 front wheel conversion done by PCW. Gave them my forks, that needed rebuilding anyway, triple tree and front axle. the front forks are machined to clear the wider brake rotor location, as are the brake caliper mounts. Spacers are made to fit the Vmax axle to the R6 wheel. Only...

That's my friend Korey! Him, his brother, and his father all have Vmaxs. Have to show it to him!! :punk:

Thanks Mark!!! and I have actually. Just finding a K&N filter with the right diameter inlet that isnt 4 inches tall has been a battle. Combed K&N's website and couldnt find one that would look right, and not hit my knees. :bang head: The quality of Uni filters have gone down considerably since...

and the other Gen one there is Darrel, the ex engine builder from PCW. He's running a Max that looks like he pulled out of a lake and pieced together out of spare parts :biglaugh: He's doing it just for fun and was doing 11.5s He's pretty tough with that thing. beat me before!

Depending on the temp and humidity, it can range from some where in the 10.9s to 10.7s. think the planets were lined up and pulled me into a 10.69 once :biglaugh: but i've never been able to repeat it. once i make my test runs it usually stays with in a few hundredths of what i dial. last night...

Love when Danny and Mike come to my home away from home! Been in kind of a slump for the last few weeks. But turned it around tonight! Thank you guys for coming out and representing the VMax! :eusa_dance: