Recent content by nightsmith

VMAX  Forum

Help Support VMAX Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. N

    Two brake line setup

    That looks good to me. I hadnt tried to route it myself yet, since I had the forks torn down. The only explanation for this and my forks taking so long is that I am an ASE(ask someone else) certified brake and suspension 'expert'. Thats my story and I am sticking to it
  2. N

    Two brake line setup

    The lines I have are pretty long so I am going to run them both to the M/C I'll just experiment. Thanks
  3. N

    Race Tech Emulator install

    Ok, I think I have this figured out. I set the emulators at 3 turns. The oil level on the old forks is 5.5 inches below the top of the compressed tubes. I couldnt get the racetech top out springs to fit in the tube, so I put a 1 inch spacer with the factory spring. The top spacer worked...
  4. N

    Race Tech Emulator install

    I am trying to put together a bit more comprehensive set of instructions for doing this install. well, trying to install my set and not muck it all up. On my 86 I am looking to drop the front about an inch. The bottoming out springs that came with the kit are longer than the stock ones...
  5. N

    Two brake line setup

    I was just wondering if anyone had some pictures of the 2 line setup. I am trying to figure out a good routing. Also, does the double banjo bolt from the divider thingy fit the master cylinder? thanks Greg
  6. N

    Key West, Sloppy Joes

    Well, I have actually rented a house for the week. Of course, the challenge is that I am driving down from atlanta ON the 19th so I was trying to talk myself into unloading and heading down there after a 12 hour drive. LOL I have never been to the keys before, but they say parking is an...
  7. N

    Key West, Sloppy Joes

    Anyone going to be in key west Sept 19 and going to Sloppy Joes for the biker bash? I'm in town for the week for vacation and dragging down the max.
  8. N

    No vboost

    I will try to get into the bike this weekend and get a pic of what I am needing. ummmm I think I know which box it is LOL I hear you on the speed thing Bill. Its the OH $#@$ factor that I am missing oh so much. I'll probably eventually go with the whatchamacallit stage 3...
  9. N

    No vboost

    Well, I dont think it is working when riding. There is always the possibliity that I am just getting numb to the speed and am an absolute power junkie. Nah that couldnt be possible.
  10. N

    No vboost

    Well, I still havent come up with a solution. I redid all the grounds cleaned all the connections did everything I could think of. Its the strangest thing. Once in a while it will ativate, but most of the time I get nothing. Does anyone have a vboost controller they are...
  11. N

    No vboost

    Yes, thats the problem. well, that and not doing its thing when riding.
  12. N

    No vboost

    this thing is driving me bonkers! I went over every connector I could find, cleaned them and put dielectric grease fresh wires on every ground, except where I just installed a twin wire. Nothing, Nada, Nil, Niente, No way jose. I dont really want to buy a...
  13. moto 0001

    moto 0001

  14. bike

    bike

  15. N

    Ground wires

    I knew it wasnt a replacement for a new one if I had a failure. But I thought the main difference between an older and newer one was the frame ground vs a grounding wire. And I am hoping I dont have to replace mine.
Back
Top