Recent content by oliver

Success. Kitchen forks should be part of any decent tool kit.

Thanks for replies. I'm going to make some long tool with edge to get behind seal and hopefully pull seal out. Fortunately I'm in no rush right now to use bike. Problem is the near inaccessibility of seal.

Hi all, I'm replacing oil seals on clutch slave cylinder. Rebuild kit came with oil seal for clutch push-rod. Although old was fine I thought I'd replace it. Trying to get old one out I started trying to put homemade prong behind seal to pull it out, then tried drilling hole for self tapping...

I've read a few more threads here under "clutch noise" and it seems everyone says a bit of rattle is normal, so I'll relax and not worry about my clutch disintegrating next time I open up the throttle. Also it's supposed to get worse if engines' running rough which mine was last few times I've...

Hi, I've got a fairly low mileage '98 model, finally got it running smooth after loads of carb problems. Anyway new problem is a rattle/rumble noise. I've worked out that in neutral with clutch lever pulled in it sounds fine. when I let out clutch there's quite an obvious rattling, gets worse...