Recent content by rbachm

There is a EFI setup for the vmax on ebay that uses the Microsquirt ECU.

Here's a tail light mod that was so easy a caveman could do it. Did not have to cut any thing off the bike so I can put the old lovely tail light back on. Found the led cateye on Ebay for $10 took some 1/16 sheet aluminum to make the bracket bolted it all up then just moved the license plate...

No pic's this time. haven't had as much time to work on this but making progress getting a good fuel map set up. Then can make adjustments to the startup and warmup setting. Had to chase down some gremlins one was with a TPS sensor then swapped out the narrow band O2 sensor for a wide band to...

Installation on bike complete, everything actually fit except for one little miscalculation. The front TB bracket where the throttle position sensor attaches was hitting the clamp on the rubber boot so had to turn the clamp sideways and nip off the part of the boot that comes out over the clamp...

Still plugging away! Finished up the fast idle bracket, did some test fitting for the fuse and relay bracket that will sit under the pass seat along with the Bluetooth dongle. Still learning about the software program and setting up the Bluetooth app. The app does some nice features along with...

hey thanks, i can just use the coil negative but I'm not sure how the ignition kill shifter or the dynatec lunch limiter will work with the microsquirt.

Finished putting two wiring harnesses together that was pretty straight forward. Had to redo a few things and make some changes along the way. Trying to make this as plug and play as possible. One other thing I have added is a fast idle solenoid for warmup. Also wired in every sensor you can...

Update, the fuel pump is in and the bike is back on the road "Oh ya". this phase was challenging I guess you can say I have some skin in the game now, literally I cut the hell out of my knuckles trying to get my hand in the cut hole to flatten down the high spots (good thing bandages are...

I did take a look at possibly increasing the size od the opening found someone one line that does custom carb work http://www.maxbore.com/ but the rubber boot only opens up about mm so would have to start carving on them (see where this is going). these will still flow by design better then the...

Making progress, completed the throttle body assembly. Everything went together pretty smooth, just a few minor problems. The next step is finishing up the fuel pump bracket and then installing everything in the tank. Once that is done and tested I can ride the bike until its time for the big...

thanks, but first mod no, I think I must be psychotic because I spend so much time and money on bikes. lets see there was the ram-air then the nitrous oh and lets not forget the shifter.

From the drawing board to reality. The plan is to make something that has the same dimensions as the stock carbs to be able to use mounting brackets, butterfly’s and linkage, along with a custom ram-air kit. The design was done with solidworks and modeled around components that are easily...