Recent content by scottp1601

VMAX  Forum

Help Support VMAX Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. S

    Looking for OEM grab bar

    I still need one. How much and shipped to Stoughton, MA. I couldn't email you for some reason. Mine is [email protected]
  2. S

    Looking for OEM grab bar

    I'm looking for an OEM grab bar for a gen 1 vmax.
  3. S

    96 part out

    I'm looking for the driver's seat?
  4. S

    best tire and size for stock rims

    I was wondering what people thought was the best tires to put on stock rims for the best handling and also what sizes for front and rear? Can you get a different size for the rear that might work better?:ummm:
  5. S

    another jetting question?

    i shouldn't use the ajustable needles or the springs or can i use them with the 147.5 jets?
  6. S

    another jetting question?

    I bought a stage1 dynojet kit and was wondering if anyone knew what i should run for a main jet. I have a k&n air filter and holeshot slip-ons. The kit says to use dj170, just think those are a little big. Dont know if i should keep the stock 152.5. Also needle height, i set them at 3 from...
  7. S

    vance and hines exhaust

    Does anyone know how the vance and hines exhaust sounds and also how it works on the vmax. I have a chance to buy a full exhaust its 2 into1 on each side.
  8. S

    yamaha fjr1300 rim fit on a vmax

    Does anyone know if you could put a fjr1300 rear and front rim on a vmax? The fjr1300 is a shaft drive dont kow how they would line up?:punk:
Back
Top