thunder

Well I said damn the torpedoes full speed ahead (after speaking with Sean for advice) I drilled a tiny hole in the speedo cover (it is...

Current set up: 700-800 ASL K&N filter float levels @17mm 152.5 mains PAJ1&2 stock Mixture screws 3&1/4 out .042 shim on needles Ok...

Thought this was a good thread to keep alive... My current setup is (SUBJECT TO CHANGE 😁) : -2000 Vmax, stock engine, 20k miles...

My Holeshots are ceramic coated which is also meant to reduce heat loss. Any benefit from wrapping would IMO be reduced? The point I'm...

I have a Canadian bike; the needles are not adjustable but they are a slightly different size with a different number. Canada - needle...

Hi Eric, I read in a carb tuning post that if the A/F setting is out more than 3 turns, it’s recommended to go up one size on the pilot...

You should be able to find Mikuni jets in the UK, try a shop doing performance work, or vintage racing, they will be able to get them...

Because I have a performance exhaust; Holesot 4 into 2, it definitely flows more air. I read somewhere that by wrapping the pipes, it...

As I replied earlier on; I wrapped my pipes with titanium wrap. The appearance of the pipes were starting to show rust, upon further...

Hi there, I wrapped my pipes with titanium wrap; my pipes were starting to rust. By doing so it retains the heat causing the exhaust to...

Spark jumps from a very small point much easier than from a large surface, like lightening hitting a antenna top in preference to a flat...

Let see Iridium NGK vs. stock NGK for the V-max? Stock NGK gen-1 V-max recommendation is to change every 4K~8k miles Iridium NGK...

Thanks John.