Recent content by yoshi

Located behind the left intake scoop.

This is an easy answer,.. the answer to what will work is.. oh no, the boss, gotta hide..brb..

V motors have to be split side ways, straight 4 cyls , you can turn the motor over and remove the transmission that way, but not in the frame.

no on seafoam, straight (crappy) gas.

Mine too, I did shim the slide needles then after some miles, I did hear a pop again. Better off the bottom though.

So why after 7 days it's still not sold? Sounds like a good deal.. I dont get it. $2800 i'd jump all over that if it was closer to Fla. I saw the same type of ad on CL here in Tampa, got my 95 Red Vmax for $1500. Cleaned the carbs and it's perfect again. Now I just have to put more miles than...

The answer is NO. The back wheel will not move freely. Unless your the HULK. Just because the engine is not running and you have it in gear and the clutch in does not mean that it will turn freely. It is in neutral with it in gear and the clutch in, but there are so many factors that come into...

DONT FORGET to clean up the slave cyl with a ball hone or some 400 wet dry. Just like replacing the rings in a 2 stroke, you need to hone the cyl for a smooth ring glide. Just the same for the slave cyl, clean it up so the piston will slide good/well. (hows my english?)

lol, if your getting Zapped from handling the plug caps, then theres one of your problems. Replace them all with $5 NGK caps from your local shop or stealership. If the caps arc to ground at idle or just above, that'll cause your misfire. They may/may not misfire at higher rpm (they might arc to...

Theres your problem.. should be around 25-40k AC at 4k rpm's. 120 Ac volts to the RR will fry it.

Water will boil out of the bike at 212 degrees, coolant/anti freeze will boil at a much higher temp. So straight water will only be temporary until it boils out., and IT WILL. 50/50 coolant is much better than just H2o. :punk: