Search results

I had posted about my expierence with front end wobble and Shinko's. I'm going to try swapping out the front with something else. The rear has barely 500 miles on it so going to try and get a little more life oout of it. I read through a bunch of threads about front tires, with a "TON" of...

Looking for any tips on where to start... 2010, Gen II with 41k on it. Just before I put it away a month and a half ago. Before I put it away I could feel a wobble, really slight if I took my hands of the bars between 45-55 MPH. Inspected the front tire (Shinkp Verge) and found a bubble on the...

When my bike is in netural and idling I hear a rattling noise on the left side, once I pull the clutch in it goes away. I know the engine isn't real quiet to begin with. Any ideas on what to check ? My starter is going bad and have to tap on it every once in a while (getting ready to replace...

Has anyone have this windshield, from Germany, not even sure it's still available ? Looking for additional pictures or feedback, did reach out to them... http://www.v-max-f-maerz.de/vmaxkatalog/770/774a_en.html Or has anyone comments on the Fly from Exactrep ...

I'm replacing my taillight and there is another yellow plug that wasn't attached. Silly question. But what is it for ? Thanks in advance

Anyone rebuild a starter on their Gen 2 ? Just wondering how difficult it is. Looks like the exhaust and radiator have to come off. The actual rebuild doesn't seem to bad. Pretty sure mine is going, intermittent non start cured by tapping on the starter. Thamks

Looking for something more sporty, like the R1 pegs, from what I can tell should be a fit. https://www.denniskirk.com/powerstands-racing/silver-sbk-pegs-for-oem-mounts-07-01203-21.p498110.prd/498110.sku Question is, there are so many out there, hard to tell which ones are the best. Anybody...

I have gear oil weeping out of this hole, I don't know what is supposed to go there. Could someone check and let me know. I looked in the manual as well as the parts breakdown. I didin't see anything.

So I snapped off the end of my hex ball wrench in the front ABS sensor bolt. Any suggestions on how to get it out ? Thanks in advance....

I want to use a UFO Twinstar muffler I had on my Hindle 4-1. The Twinstar will not clamp on the Hindle tightly, leaving a gap. I was also going to weld a tab on for the spring, it would be secure, but still wouldn't be a snug fit. Any suggestions ? Thanks in advance.

Putiing on a new 4 into 1. Can not get the rear to line up......any suggestions. I've got a 1/4"gap and it's really close to the heat shield..... Thanks in advance.....

Putiing on a new 4 into 1. Can not get the rear to line up......any suggestions.. Thanks in advance.....

When replacing front pads, do I need to replace the pad support springs each time in the front ? And with the back pads do the shims need to be replaced each time ? I'm assuming if they're in good condition I dont need too. I didnt see anything in the service manual.... Thanks

Hi all, New member with a new to me 2010. I've been looking at swapping out the bars and have came down to either a drag bar or low superbike bar. I found these and they seem preety nice. https://spieglerusa.com/controls/handlebars-accessories-100/x-bar-handlebars/color/black.html...