Search results

Looking for some fellow Vmaxers to ride with in the four corners area. I am in the SW corner of Colorado. It would be nice to ride with other Vmaxers instead those guys on those slow ass pigs, oh I mean hogs. Ride safe.

I recently recieved a Ignitech kit. Install was fairly simple. Programming is a bit more difficult. With the kit came a disc with what I assume are programmed set-ups. When I try to upload a set up I get a text (key). Which I don't understand. I'm just trying to get a starting program for...

I ordered replacement screw due to a stripped screw right rear carb. The carb was a bit rich and I could not adjust screw. When taking the old screw out it was very very tight. I see why it was stripped in the 1st place. When I look inside the carb I see no obstruction, but the the screw will...

1st Gen. Black Supertrapp slip-ons with slight damage to the right side one. The left is in great shape. Both fully fuctional. $200. Sent from my SAMSUNG-SM-G900A using Tapatalk

I've been working on my 96 all winter. I've done most of the maintenance stuff such as changing all fluids , filters, and leaky seals and battery . I updated the shift segment. Replaced brake rotors and pads. Replaced clutch basket, plates and clutch line to SS, I rebuilt master and slave...

I installed some frame braces yesterday. It did tighten up the bike and made the handling a bit better. I do have a bit more vibration now. Is this normal? Is there anything that I can do to cut down on the vibration? Sent from my SAMSUNG-SM-G900A using Tapatalk

Im looking for a good shape in working order Rotor /Flywheel for my 1996 vmax.

I replaced the starter clutch and rotor/ flywheel due to some damage. The bike ran fine before I started the swap. Just had grinding starts sometimes. I put it all back together and now I have no Spark to the plugs. Coils are good I have power where it is needed, just no spark. Somthing with...

I have remove the rotor/starter clutch assembly. I noticed what looked to be little chunks of epoxy. Not a lot just a couple tiny pieces. Closer inspection I noticed the rotor is where it was coming from. The cover on the edge was slightly damaged previously. I have a rotor/starter clutch...

Looking for frame support / braces , black is prefered but not a must.

I've been addressing my clutch issues since I've got the bike. It would die while in gear with clutch lever pulled. It looked as though the fluid had never been changed. I rebuilt master and slave cylinders. I also replaced stock clutch line with SS . New long pushrod and new bearing. The...