Search results

VMAX  Forum

Help Support VMAX Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. Stigmata

    start/kill switch assy

    I need to replace my start/kill switch assy. Has anyone done this? Where would I find step by step instructions?
  2. Stigmata

    brake caliper rebuild

    I knew something was wrong when you stated remove cap, not the one on your head. When it came to this step I kept taking my derby off. Poblem solved, I now have brake pressure. Thanks for the tip. You Brits are so smart
  3. Stigmata

    brake caliper rebuild

    Have you tried the hydraulic brake bleeder by Motion Pro? I picked one up on Amazon for $14. Doesn't look like much but works fast. Less then two minutes and I had good brake pedal pressure.
  4. Stigmata

    brake caliper rebuild

    Thanks for your advice. I just purchased a mityvac. Next time I will try the reverse bleed.
  5. Stigmata

    brake caliper rebuild

    Thanks for the tip. I will invest in one.
  6. Stigmata

    brake caliper rebuild

    Went out this morning and tried to bleed brakes again. This time I used a Motion Pro brake bleeder ( a one way valve to make sure air doesn't go back into the system ) and It worked fine. I now have brakes. Couldn't explain what went wrong. It didn't make any sence. I've bled plenty of brakes...
  7. Stigmata

    brake caliper rebuild

    Yes, when I replaced the seals a few months ago. Had pressure and worked fine. Will investigate further
  8. Stigmata

    brake caliper rebuild

    The master cylinder is brand new as I had brakes before. What am I looking for? What test can I do to see if its working as it should?
  9. Stigmata

    brake caliper rebuild

    I just rebuilt my rear brake caliper with a piston and seal kit. I went to bleed the system and saw brake fluid exit the bleeder screw into the tube about 3 inches. Couldn't get it to drain into the bottle on both screws. Thought it was strange that I didn't have to add fluid to the reservoir...
  10. Stigmata

    brake caliper rebuild

    No corrosion anywhere. The piston was clean as the day I put it in. Brake fluid looked brand new also. Just ordered a piston & seal kit from Brake Crafters. Once in I'll see if the pistons retract properly and keep you posted.
  11. Stigmata

    brake caliper rebuild

    When I rebuilt the caliper 3 months ago I also installed a Galfer braided line. I will measure the thickness of the rotor. It's an EBC. Once I change out the piston and seals I will rotate the wheel on a stand to check for any drag.
  12. Stigmata

    brake caliper rebuild

    Also when rebuilding brake caliper is it best to lubricate the seals and pistons with brake fluid or the red rubber grease?
  13. Stigmata

    brake caliper rebuild

    I noticed that the OEM caliper rebuild kits are about $200 for a full kit with pistons. I can get a full kit from Brake Crafters for around $78. Is there really a difference? Has any one used this company?
  14. Stigmata

    brake caliper rebuild

    When I did a rebuild 3 months ago I cleaned the grooves with a dremel. The pistons where a little corroded so I cleaned them with a 3m scotch brite pad. When I popped out the piston yesterday it was clean. No sign of corrosion or debris. The inside where the piston sits was also clean. I'm going...
  15. Stigmata

    brake caliper rebuild

    I put in a new rear master cylinder and changed the fluid 3 months ago. I held the other piston in with a piston spreader while I pumped the brake and the other piston popped right out. The piston was clean and no debris or corrosion inside where the seals are. I'm going to pop the seals out next.
  16. Stigmata

    brake caliper rebuild

    I removed the brake pads and noticed that one of the pistons didn't retract.
  17. Stigmata

    brake caliper rebuild

    I took it apart, cleaned everything and only replaced the seals. The pistons didn't look bad but I cleaned them anyway with 3M scotch brite pads. I also installed a new master brake cylinder and bled the system. The rotor still gets way too hot. I'm thinking the only thing left to do is replace...
  18. Stigmata

    brake caliper rebuild

    It's an 86. Thanks
  19. Stigmata

    brake caliper rebuild

    Im going to rebuild my rear brake caliper. Any sugessions on a good kit? I saw a kit from the UK called brakemasters but don't really want to wait that long to receive. Saw another brand from Brake Crafters that I can buy in the USA.
  20. Stigmata

    engine oil leak

    Have an oil leak on my 86 max. After a ride I noticed a small dime size oil spot near kickstand. Not coming from the stator cover but found oil dripping from the choke lever, and front bottom of air box is saturated. Also noticed oil running down the radiator hose that attaches to the left front...
Back
Top