Search results

Good luck!..please!keep us updated 🍻

Ok,great!..Thank you for your help,,,

I try to find out how many and type of tools were included in the ´86 Vmax tool box...there are many "kits" on sale around,each of one with diferent kind of tools around..Could anyone help me with this?I have not been able to find information about it....attach picture,of one that I feel is the...

..good upgrade!!..do you have any picture?..

Thank’s for the reply…No,I did not..what I see is that the “entrance “ is rounded instead of square..I will try your idea and also to “force” the Speedo cable more into it,to get more “contact”,by the way,do you know what will it be a good price for a mph/km’s speedometer replacement?

Hello,my 86´speedometer input "square" fitting is damage ,Do you know if it can be opened and replace that part(looks like it is fitted by two philisps screws to the housing). I have an European Km´s speedometer with 6000 km´s that I could swap the conection if it will posssible to "open" it...

Hello again Kyle,I was checking the K&L catalog and I have not been able to find the rubber washers for the Vmax 85-07...maybe they discontinued.. www.https://www.klsupply.com/

Thank you very for your support Kyle...I will..

Good point Mark!!..Thank you !

Thank you very much for your recomendations CaptainKyle !!!

Hello,my ´86(48.000 miles...) needs a valve gasket replacement due to some oil leackage throughout some areas of the cylinder heas...I would like some tech advise ,I have to replace the valve cover gasket,my worrys are; *Do I have/should to replace the rubber/washers of the valve bolts...

🤣🤣.. problably not has the problem of the oil level during hard acceleration..😂

Sorry 99YamahaVmax,I´m with Fire-medic..it is a very good good recomendation of replacement,is it expensive?,well..it´s a fuel line...it is just an opinion..🍻

..same as Maleko..please share the tips or post for future use by other...specially the good tips!!

Pressure sensor ok...(well,looks like it was not" firmly attach" ..the diference now is that,I can disconect the servomotor(keep the Vboost always open..)nad the fuel pump does not "run all the time",when I start the enguine...I will made a test ride....

Thank you *MaxMidnight,Pressure Sensor according to the manual,isn´t it?..I will check how it works according to the manual.. I will foward the investigations of both parts.... 🍻

Sorry *fire-medic but in my previous answer I only had "the first line of your comments" The Ignition Advance Unit is "Inside" of the Ignition Control Unit(CDI),isn´t it?... Buff,I will take a look at the Vboost Control Unit...see how it looks inside.

Thank you *Fire-medic. I think so..but what its extrange is that before I did not have any "issue" ,fuel and controller were "working" even whithout the buterflys removed... I just want to eliminate parts involve in this failure..my first thought was the fuel relay also....and since my last...

Hello,I have a problem since I install back the Vboost "buterflys" ;Yamaha year 86(USA ,not CA model) ,KerKer + Dyno7. Problem; The bike had the controller and servomotor installed and "conected" before I install the "Vboost hardware",no noise before,(before the installation,without the...

Maybe it helps..french´s frame v-max(not sure the year,I think 1996 and up...)..