Search results

Does anyone know what color red came on the vmax in 1995? Where can I get this paint? Thanks

Is it true that the 85 vmax is the only one that made 145 hp at the flywheel? If so why is this and how can I get my 95 up to the power level of the 85? Thanks, Joey

Anyone in the states seen or have the center outlet 4-1 exhaust that exits under the tail? The home depot bike from cannes moto services has this exhaust. Just do a search. Thanks

If anyone has their engine apart and can measure a few things for me it would be greatly appreciated. 1. cam duration {stock} 2. intake and exhaust lift 3. cylinder head port lenth from valve seat to flange of cylinder head, intake and exhaust. 4. Minium cross section of intake and exhaust port...

How much can you shim stock needles before they stop making the engine richer? Thanks, Joey

Anyone made them for the vmax?

Anyone know what the fuel pressure is susposed to be on the vmax? I am having cylinders drop out almost like its running out of gas. Checked psi and it only has about 1.5 psi. Is the pump bad? Thanks

I just have some rubber boots shoved into the mixture screw holes to protect them from getting dirt in. I removed one and noticed fuel in the hole. Anyone seen this? Is it a concern? Thanks

I have a 95 vmax all stock except for the v boost being open all the time. I have the mixture screws out 4.5 turns and can't seem to get the idle rich enough. It has a stuble off idle until about 5000. I am guessing I need to fatten up the idle circuit. How do I do this? Thanks for your help

1995 vmax I'm having trouble with the push button starter switch. First couple of starts are fine but after that the bike will not run until you release the button. If you barely push on the switch you can get it to fire. The side stand switch has been wired together, but I left the side...

Does anyone make an ignition box or add on box to interrupt igniton at a certain set point to provide full throttle upshifts clutchless?

Has anyone heard of the VTAC shift light and rev limiter? It also allows full throttle clutchless shifts. At a preset RPM the unit briefly interrupts ignition, releasing the load on the tranny so it will go into gear without the clutch. Please let me know where to get one. What do u think of...

So I drilled out my brass plugs and instead of a screw it looks like I have a brass plug with a hole in the center of it. I know I didin't hit the screw with the drill bit because I was able to pull the plug out almost intack. Anyone seen this?

The factory service manual states that the firing order is 1-3-4-2, but on the same page it shows a diagram that coflicts this. Per the diagram it looks as if it is 1-3-2-4. Which is correct?

Is there any reason that there is a thermostat in the vmax? Its not like a car where you need the thermostat for the heater. I was thinking of removing only the guts of it so there is still a restriction but no valve. Any thoughts?

Does anyone know where I can get front and rear stands for the first gen. Vmax? I am wanting the type that lift the bike by the forks and swing arm, just like the sport bikes use. Thanks

How can I tell which vmax I have? According to the service manual there are 3 supplementary manuals, each apply to a different VMX12 prefix. Example VMX12H, VMX12HC, VMX12N, VMX12E, VMX12U, VMX12S. I realize that my serial # should match sertain digets, which would tell me which model I had...