Search results

VMAX  Forum

Help Support VMAX Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. jwood

    CrankCase Cover 2 question

    Can anyone answer if the CrankCase cover 2 is THREADED for the drain bolt? I am having a slow "drip" from bolt 21 and crush washer 22, I am not seeing any threads in the "cover" for this bolt, the question is should there be??
  2. jwood

    WANTED: frame Braces for a 99

    Looking for a set of frame braces for a Gen 1 .... Please pm if you can help....
  3. jwood

    A/F Needles

    I am getting ready to replace my corrosion infested AF needles, do i need to drain the bowls first? If the needles don't come out I know I can blow some air down the PAJ to set them free, but can this be done "without" disassembly of the diaphragm covers and removing the slides first?
  4. jwood

    Casa Fiesta Norwalk, Ohio 6/27/14

    I was in town eating dinner, as we were leaving saw a Vmax parked on the side of the patio! anyone's here?
  5. jwood

    Stupid Weather

    80 degrees the last few days, wake up to snow accumulation of 2" this morning! Back to the 70's this week... Sent by the Verizon 4G Data Network
  6. jwood

    Hard Cold Starting with Carb Farts!

    I have been having a new issue that just started this riding season, when the bike is warm/hot no problems starting, when the bike is COLD from sitting a few hours to overnight, I put the choke on and my Odyssey battery turns the engine over at a great pace! the carbs (not sure which one(s)...
  7. jwood

    GPS Speedometer

    Has anyone replaced the factory speedometer with a gps speedometer? If so which one, how did it mount up, photos? Sent by the Verizon 4G Data Network
  8. jwood

    Stage 7 Float Bowl Vacuum Hoses

    I am getting mixed answers to this question, can anyone here give their view :bang head: Stage 7 with Pods what do you do with the float bowl vent lines??? Some say remove the hoses from the carbs. some say you need to keep them connected to the carbs and allow the hoses to lay in the...
  9. jwood

    Need some help....

    Now Here is my set up... UFO Quadzillas, Stage 7 kit with K&N pods, stock PAJ1 & 2, DJ 165 Main, Stock Springs, drilled slides, Needle 4th clip from blunt end, and A/F set at 2.5 turns, V-BOOST is unplugged and full open.. sync is perfect... The bike runs great above 3000 RPM, pulls like a...
  10. jwood

    Gen 1 fork diameter?

    What is the diameter of a generation 1 Front Forks, I am looking at doing a headlight modification over the winter... Sent from my Galaxy Nexus using Tapatalk 2
  11. jwood

    Fork Seal

    I just had my bike lowered 2 inches in the front with progressive springs with no air pressure, last night on the way home while running 75 mph on the expressway I noticed a slight vibration in the front end and looked down to see fork oil leaking out of the left fork, when I press the handle...
  12. jwood

    Gas Mileage

    My last tank of fuel when the reserved kicked in was 122 miles... Over 45 mpg! When I run the tboost on at 3000 rpm only getting high 20 to low 30 mpg... :banghead: Sent from my Galaxy Nexus using Tapatalk 2
  13. jwood

    Speedometer 99 Vmax

    I took a ride today with 17 other bikes, and noticed "we" were all riding at 75MPH on the open road as a group! I pulled up to another bike and his speedometer was showing 65 and mine was 75... I am running a 170 rear with stock rim, and a stock tire size on the front with stock rim, what would...
  14. jwood

    Oil...

    I have owned my max for 6months now and preparing for its first oil change... How much oil does the vmax hold and what brand and weight is recommended from the fine group here? Sent from my Galaxy Nexus using Tapatalk
  15. jwood

    Fuel filter replacement....

    I am replacing my fuel filter on a Gen1 Today, is there anything i need to know?.. Will fuel pressure build back up when the ignition is on and the fuel pump engages? Sent from my Galaxy Nexus using Tapatalk
  16. jwood

    LED Brake Light Help..

    I will try to explain this issue I am having in the easiest way possible... I have a 99 Vmax, I replaced the rear Brake light with an LED light from http://www.motorcyclemods.com/ The light works great! it has a 3 wire hook up 1 ground, 1 brake and 1 wire for tail lights, now here comes the...
  17. jwood

    Identify

    Can someone tell me what this round barrel item is? I don't see a thing about it in the service manual... Is it just a wire bus? It is located under the left scoop with the relays.. Thanks... Sent with the Galaxy Nexus LTE
  18. jwood

    SeaFoam

    I have used SeaFoam for the past year in the fuel tank, has anyone used it the crankcase in the Vmax? Sent from my ADR6300 using Tapatalk
  19. jwood

    VMAX1200 intake flare fitting

    Have you guys seen this? Looks nice!... $$$$$$$$$$$$$ http://cgi.ebay.com/ebaymotors/Yamaha-V-Max-1200-V-Stax-Carburettor-Covers-set-4-/120762954287?pt=UK_Motorcycle_Parts&hash=item1c1e08722f And...
  20. jwood

    Anyone in the Cincinnati, Ohio area?

    Subject said it all... Sent using the Wireless High Speed Data Network on Verizon Wireless
Back
Top