miss

VMAX  Forum

Help Support VMAX Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. pumacorp

    When I put left blinker on I get miss in motor

    Only when I use the left blinker I get a miss in the motor...When the blinker is turned off its fine...Its fine with the right blinker..Both blinkers work the same and blink fine...Strange..Help
  2. R

    miss when cold

    My Vmax is new to me so I dont know what they act like when cold. Is it normal to miss fire when cold (less than 60 deg outside)? When the engine is cold it seems to miss on random cylinders. I have not done much to my 85 vmax other than a carb cleaning. If one drives only a block or so it...
  3. kozy

    What did I miss?!?!?!?!?

    I just saw the thread in the Graveyard of someone bashing Lankee. Did he get pissed and leave or something??? I just tried PMing him and it's showing that he's not a member anymore!!!!! He was going to powdercoat my exhaust for me. I already had the materials mailed to him and now I can't...
  4. HDKILA

    Idle problem resolved now back to the high rpm miss...

    Ok folks I figured out my high idle and I still am having a high speed miss. I have ruled out anything in the carbs and my synch is good to go. The bike runs like a freight train until 6-7k rpms and then misses all over the place until redline. I have yellow spark plug wires and have...
  5. HammerZR-1

    Miss under acceleration

    Hey Guys, Idled good after warmup and under acceleration on a ride last weekend, but Max was running ragged at cruise. Was going to do the Shotgun and noticed the carbs weren't seated in the boots and the clamps were loose so took care of that. It ran better, but as I was headed home and got on...
  6. Lew L

    High speed miss

    I took the "Y" off my Max today and after the bike was warmed up, it would miss at about 6000 RPM. It ran fine just a day ago. It didn't matter which position the T-boost switch was in. Low speed is just as normal---- very good. So I've put the "Y" back on, checked the plugs and replaced the...
Back
Top