Sometime my A/F air fuel screws will came out of sync. I was trying few ways to make them hold up longer with out using something on the a/f screw to stay longer. I tried a few different things and this is what I came up with and it works for me. I been riding the bike hard and took to the drag strip and few wheelies. A few 135 miles in hour runs to.
I used 1/8 in diameter silicone hose and 5m x 30m allen head screw, and install the screw in side the hose. The hose should be 10m longer the screw. Install the hose/screw in the a/f hole push in until you feel it stop now hold it there for a few seconds the extended hose will keep the a/r screw from from turning by pressing on it. This works for me.
"O" I used a wire tie to find how deep the hole is. I bend the tip.
The hose must be a silicone type that kinda sticky like or stick to your hand when you slide it in your hands.
Also it keeps out the dirt and it looks cool to.
I used 1/8 in diameter silicone hose and 5m x 30m allen head screw, and install the screw in side the hose. The hose should be 10m longer the screw. Install the hose/screw in the a/f hole push in until you feel it stop now hold it there for a few seconds the extended hose will keep the a/r screw from from turning by pressing on it. This works for me.
"O" I used a wire tie to find how deep the hole is. I bend the tip.
The hose must be a silicone type that kinda sticky like or stick to your hand when you slide it in your hands.
Also it keeps out the dirt and it looks cool to.
