95spfldmax
Well-Known Member
The friction plates have one semi circle (notch) on one side and a double on the other side. I assume they line up together but do they need to fit to the clutch basket in a certain orientation?
Barnett Clutch Question
- Thread starter 95spfldmax
- Start date
Help Support VMAX Forum:
[email protected]
Well-Known Member
Per the lvlhead site
*The friction plates are marked on two ears. A single cut on one ear, and a double cut 180 degrees from there. All similar friction plate ears should line up with the indicator of the clutch boss. If clutch drag is noticed after reassembly, Yamaha recommends to rotate all friction disks 180 degrees with the friction plate alignment indicator on the clutch boss.
*The friction plates are marked on two ears. A single cut on one ear, and a double cut 180 degrees from there. All similar friction plate ears should line up with the indicator of the clutch boss. If clutch drag is noticed after reassembly, Yamaha recommends to rotate all friction disks 180 degrees with the friction plate alignment indicator on the clutch boss.
