Billet Ignition cover problem...

VMAX  Forum

Help Support VMAX Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

ghostntheshell

Well-Known Member
Joined
Apr 23, 2009
Messages
1,283
Reaction score
1
Location
toronto
Installed my billet ignition cover today.
Looks way better than the chewed up stock ignition (looks like someone once used a screw driver)

But the key can't enter the ignition properly with it on.


I will attempt filing down some of the rubber on my actual key...

for now my first mod is a dud :p
________
lolol
 
Last edited:
I encountered the exact same problem with mine.
Just grind a tad of the rubber corners of the key and it'll be fine.


Installed my billet ignition cover today.
Looks way better than the chewed up stock ignition (looks like someone once used a screw driver)

But the key can't enter the ignition properly with it on.


I will attempt filing down some of the rubber on my actual key...

for now my first mod is a dud :p
 
I figured out what the problem was with mine...

Regular starting of the ignition, no billet cap:

PUSH in key.

Release push, and turn key.

Problem:

Pushed in Key (Billet cap does not allow the release of the push)

Can't turn key.



Solution :

Find the seating area for the billet cap where it allows the release of the push, unobstructed, and glue (or whatever method you are going to use) it in place.

Turn key and start!
________
Henry II
 
Last edited:

Latest posts

Back
Top