Carb sync - cold or warm engine?

VMAX  Forum

Help Support VMAX Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Gally

Well-Known Member
Joined
Jan 13, 2008
Messages
57
Reaction score
0
Location
Middle East
I am going to use my Morgan Carbtune Pro for the first time. I read that I should set up the tool first on a cold engine, then choke and warm up the bike a bit then start the process after no choke is needed.

Would it be ok to go for a ride around the block to warm it up a little before I install the tubes on the spigots and start ? Which is best for the best reading?
 
If the temp gauge needle hits the first line it's warm enough for a sync.
 
I sync'd mine as soon as it would idle without the choke at the normal speed. Right around that first line on the gauge.
 
I agree with Quarterhorse. Good idle with no choke. Around the block usally works good.
 
Thanks guys....did the sync this morning and only took about 15 min. The Carb tune is awsome!:clapping:

Max is running Smmmooooooootthh........
 

Latest posts

Back
Top