firefly
Well-Known Member
Now with a 17 inch front wheel I see a lot of room for a sturdy brace that can also act as a one inch spacer.
Can some one make a CNC brace/spacer to fit under the stock brace for added stiffens of the forks? I think this would be a great solution to REALLY firm up the front.
I am thinking of something that is contoured to the inner side of the forks at the wide part just under the stock brace and clamps to hold it on the outer side of the forks wide sloping area.
I will try to take an impression of it using putty which hardens when baked in the oven then take it to a machinist to make it out of aluminum.
________
Toyota Corolla Levin and Toyota Sprinter Trueno history
Can some one make a CNC brace/spacer to fit under the stock brace for added stiffens of the forks? I think this would be a great solution to REALLY firm up the front.
I am thinking of something that is contoured to the inner side of the forks at the wide part just under the stock brace and clamps to hold it on the outer side of the forks wide sloping area.
I will try to take an impression of it using putty which hardens when baked in the oven then take it to a machinist to make it out of aluminum.
________
Toyota Corolla Levin and Toyota Sprinter Trueno history
Last edited:
