Front brake light pressure sensor question

[mundmc]

I finally decided to address my leaking front reservoir by buying a Shondy Shindy 17-651 Silver Body/Silver Lever Brake Master Cylinder Kit https://www.amazon.com/dp/B003YI9UJ2/ref=cm_sw_r_cp_api_ERKQyb60Z1QAN after reading good reviews.

The question: it doesn't have a brake light switch. Any input on which hydraulic brake light sensor to get?

I believe my new master cylinder uses stock banjo-bolts, or at least I hope it does.


Sent from my iPhone using Tapatalk

 

[mundmc]

To clarify, I think the stock banjo bolt (and what the above Shindy uses) is M10x1.25, and I assumed something like this would work:
Goodridge BL Banjo Bolts With Built-In Pressure Switch - Single Bleed - 10mm x 1.25 PBL992-32CH https://www.amazon.com/dp/B000GTV0RC/ref=cm_sw_r_cp_api_NhLQyb41JQEFA


Sent from my iPhone using Tapatalk

 

[dannymax]

That's a slick set-up! :thumbs up:

 

[[email protected]]

The banjo bolt switches work just fine. I'm running on on an aftermarket front brake master.

All the switches I found had bullet connectors but the bike has blade connectors so I had to replace them.

Sent from my SM-G930V using Tapatalk

 

[mundmc]

The banjo bolt switches work just fine. I'm running on on an aftermarket front brake master.

All the switches I found had bullet connectors but the bike has blade connectors so I had to replace them.

Sent from my SM-G930V using Tapatalk

Turns out I'm a jackass, and the Nissin master cylinder HAS a connect for the brake light.


Sent from my iPhone using Tapatalk