Hindle 4 into 1 help

[Ukemax]

Putiing on a new 4 into 1. Can not get the rear to line up......any suggestions.

I've got a 1/4"gap and it's really close to the heat shield.....

Thanks in advance.....

 

[Fire-medic]

Make sure that the gaskets are in the cyl head ports before all this begins. I always just start the nuts, leaving everything loose, and then work to get the pipes all inserted well-into their respective locations, and start to finger-tighten the nuts & bolts. As you get the nuts/bolts/screws snug, keep getting everything aligned properly, until you can torque the fasteners to final spec. After a coupe heat-cool cycles, check the tightness of the fastens.

 

[Ukemax]

Finally got it done....
What a PIA....
Want to thank Sean Morley for his help and super service on getting my exhaust...
Thank's to all that chimed in and thank you to Mike Kemp for the extra little tips which got me over the hump....
Before and after....

 

[KSMAX]

Finally got it done....
What a PIA....
Want to thank Sean Morley for his help and super service on getting my exhaust...
Thank's to all that chimed in and thank you to Mike Kemp for the extra little tips which got me over the hump....
Before and after....View attachment 69996 View attachment 69997

Just saw this. Sorry so late, but glad to help. I get so much help from fellow VMAX owners, I feel great helping where I can. Enjoy that Hindle. Mike Kemp aka KSMAX