how do i adjust my float height 1998 vmav

[aldo123]

iv had bother trying to get my vmax to run correct , iv done everything possable accept check the float height, i mean how can they move from the original manufactures setup , so is it just a case of bending them, i cant see and adjusting marks or anything, help me out guys on how to do this plz but i still dont understand how they would be upset because iv had the bike from brand new and never had the bowls off it
thanks in advanced. aldo

 

[SpecOps13]

Scan through the index here, there are threads that can better answer your questions than I could possibly do.. See Link Below. Good Luck Bro...

http://www.vmaxforum.net/forumdisplay.php?f=6

 

[overzat]

setting dry floats in carb section is what i just did all of mine were rich

 

[dannymax]

iv had bother trying to get my vmax to run correct , iv done everything possable accept check the float height, i mean how can they move from the original manufactures setup , so is it just a case of bending them, i cant see and adjusting marks or anything, help me out guys on how to do this plz but i still dont understand how they would be upset because iv had the bike from brand new and never had the bowls off it
thanks in advanced. aldo

They can probably move from jarring, bumps, etc.

But don't make the mistake of thinking the factory settings are right on the money....they aren't.

Check these threads: http://www.vmaxforum.net/showthread.php?t=1427&page=5&highlight=setting+float+levels

http://www.vmaxforum.net/showthread.php?t=17274&highlight=setting+float+levels

Good luck! unk: