I want blinking coils! COP.

[DreamV4]

Tomorrow I will get ordered 2.2 Ohm resistors and install them instead of bulbs on COPs. But I still want Christmas tree (most likely GoldWing disease). Any ideas which LED and resistor? Any smallest LED and resistor (about 300 Ohm or so) will do. I don't think it will cost more than $5 for all 4.
Following these steps to calculate resistor value for LED Lighting by 12V, DC:

1. Determine the voltage and current needed for your LED.
2. We’ll use the following formula to determine the resistor value: Resistor = (Battery Voltage – LED voltage) / desired LED current.
3. For a typical white LED that requires 10mA, powered by 12V the values are: (12-3.4)/.010=860 ohms.
4. To use several LEDs in parallel, sum the current values. From the example above, if we use 5 white LEDs the current requirement is 10mA x 5 = 50mA. So (12-3.4)/.050=172 ohms.

600 Pack 1/4W 1% Metal Film Resistors Assortment Pack 30 Values (10 Ω - 1M Ohm) 845832029603 | eBay

Find many great new & used options and get the best deals for 600 Pack 1/4W 1% Metal Film Resistors Assortment Pack 30 Values (10 Ω - 1M Ohm) at the best online prices at eBay! Free shipping for many products!

www.ebay.com

150pcs 3mm 5mm LED Light Emitting Diode White Red Green Yellow Assorted DIY Kit | eBay

Find many great new & used options and get the best deals for 150pcs 3mm 5mm LED Light Emitting Diode White Red Green Yellow Assorted DIY Kit at the best online prices at eBay! Free shipping for many products!

www.ebay.com

 

[02GF74]

unless we know where in the circuit you intend to fit the LEDs and drop resistors, the above calculations aren't useful.

 

[child_of_fire]

I think he mostly talks to himself.