A few days ago I was driving home on my vmax and I pulled in the clutch to coast and noticed the motor had completely cut off. I did this a few times noticing that the rpm wouldnt even stop at idle and would just completely turn off and not even hang at idle. When I got home I fiddled with the idle screw to no avail and no response. When i choke the bike, I can get it to idle but when I take choke off it will either hang at 500-600 rpms for a few seconds or just cut straight off unless i give it some gas. It runs good enough (going to take it to a shop to have it tuned/adjusted) but I was wondering if there was any solutions that you guys could think of that doesnt involve the carbs open on a work bench.
Help Support VMAX Forum:
Change out your fuel filter and clean the carbs. Shotgun them a couple if time, maybe the peashooter also. Then sync.
