Schaef77
New Member
I installed a ignitech unit last summer and it ran great. This winter I decided on a venture 1300 swap and it went without a hitch. Well now I’m wrapping it up and I ran the bike for about 30 seconds then turned it off because I wanted to mess with the vboost control a bit. In the process of doing that I mistakenly reset the settings on it and now I can’t get it running at all. I can manually move the servo and fire the ignition coils through the software but when I crank the engine and have the monitor pickup coils window open I’m not getting any readings.
Any advice would be greatly appreciated
Any advice would be greatly appreciated