ISO Grips on a 1st gen???

[SDB]

Bought some 6241 Kuryakan ISO Grips (7/8 in). Did not come with throttle tube so I bought one and put in. Throttle side done and good. Clutch side grip is too big. I used some Gorilla Glue black Duct Tape on bar. Used Gorilla Glue superglue but did not as here to tape apparently. I'm going to try a single layer electrical tape over Gorilla Glue Duct Tape (think glue will adhere to electrical tape).

Anyone else running ISO Grips on their 1st gen Vmax? Contacted Kuryakan to see if there was an insert for clutch side but they said no and that they do NOT make any Grips for a 1st gen Vmax

 

[one2dmax]

I have sold many ISO grips through the years for the Vmax and keep some in stock. You will have one with a larger hole for the throttle sleeve and the other with the smaller hole for the bar left side. They include grip glue (superglue) normally and are tight even without that. If you have two large ones then it was likely incorrectly packaged.

 

[SDB]

Yep... Had to get a plastic throttle tube insert for the throttle side and lutch side is too big (must be for 1in bars). I'm going to try electrical tape over what Inhave on the bars and then glue. If that doesn't work I'm going back to what I had on there.

Really wanted the ISO-Grips for the vibration at 90mph on highway (5500 rpm is pretty hand numbing for 400+ miles)

 

[one2dmax]

I like the ISO Flame and the newer ISO Kenetic as well.

 

[Zeus36]

Not a fan of the chrome ISO Grips. The model 6345 ISO Grips in gloss black version is not bad.

 

[Julian Tomkins]

can you fit a grub screw in them

 

[Zeus36]

can you fit a grub screw in them

You can put a set screw in any metal grip.

 

[SDB]

I cleaned off gorilla glue and gorilla glue Duct Tape... Applied one layer of electrical tape... More gorilla glue and works good. Inwould have preferred all black but I got these brand new in box for $30 locally. Works great for dampening vibration which is what I wanted.