Stage 7 needles washer

[Coffinator]

What does the little washer on the needle that goes between the E-clip and big washer do in a stage 7 kit? Does it REALLY need to go there?=)

http://www.dynojet.com/pdf/4716.pdf

 

[one2dmax]

It is for 1/2 needle adjustments. Only used if you need just a little more fuel then a certain clip setting but the next clip is too much. It would go between the clip and retainer. NOT on top of the clip under the spring seating washer (you'd be surprised how many carbs we take apart that are incorrectly assembled).

 

[Coffinator]

It is for 1/2 needle adjustments. Only used if you need just a little more fuel then a certain clip setting but the next clip is too much. It would go between the clip and retainer. NOT on top of the clip under the spring seating washer (you'd be surprised how many carbs we take apart that are incorrectly assembled).

Ah, figured it would not do much good there, was just confused by fig A on the instructions for a moment..

 

[jwood]

It is for 1/2 needle adjustments. Only used if you need just a little more fuel then a certain clip setting but the next clip is too much. It would go between the clip and retainer. NOT on top of the clip under the spring seating washer (you'd be surprised how many carbs we take apart that are incorrectly assembled).

I was wondering the same thing, looking at the manual for the DJ7 kit, it tells you to put it under the large washer, no where does it tell you its a shim!:bang head:

 

[PATMAX]

Look up Paul's Shim Kits for info