Scrape

This bike is addicting with the "rip" part. So tempting to crack the throttle too much on a leisurely cruise. OOps, dropped the ball...

I'll do it tomorrow, started it up but haven't run it all winter. Going out for a ride now and give this thing some exercise. Not...

I just edited it but still not happy. Taking it outside

Yes, maybe I should go outside

Sure, I'll put one together today. Sounds better in person but I'll see if my phone video is acceptable for representation.

Maybe nut-serts?

I do know that the OEM pipes were too quiet, I couldn't hear the motor in the wind to shift right. The tach should be up higher with...

Thanks, never thought about those and would hold better than screws. One of my initial concerns was to make the pipes look like they...

I ran a test on spacer thickness with the five 7/16" holes. 1/4" was a little bit too much uncorked for me and needed some more...

Cool video of some radical builds. Maybe some of you know these people and bikes.

If you just want to hear it, like I did, consider drilling out the stock pipes. Takes a few minutes and cost $0.00.

Mine are drilled now with five 7/16" holes and drilled pennies as spacers. I have heard many bikes in my life but not the V-Max except...

Or if you just want a bit more noise you can drill the OE silencers.