Carb #2 leaking....

[Shuriken]

I assume the float level is too high or the float needle is sticking on my #2 carb because fuel oozes out around the rubber intake manifold boot and down the engine. It's been doing this a while and now it has wrinkled the chrome plated plastic H cover on that side.

What do you guys advise I should do? Check / adjust float height?

 

[maleko89]

Check the outer edges of the float bowl cover, choke plunger and slide cover. Also make sure boot clamp is tight. Remove drain screw to that carb and check condition of the o-ring.