I just went for a ride after putting in my Morleys jet kit.
My setup is
I used Seans needles (stage 7?)
Put in the air correctors
157.5 mains
STD springs
Idle screws 3.25 turns out
V-boost programmed to start opening just before 4000RPM
Seans airbox lid
Marks exhaust 4 into 2
The main problem is it stumbles when trying to cruise below 4000. If the needle is just past 4000 it's fine, and accepts WOT there without problem.
When it's stumbling, opening the throttle a bit more makes it pull OK. Just won't cruise or gently accelerate with minimal throttle.
On the freeway at 4000 in 5th it cruises, and WOT works good, no stumble. :biglaugh:
What do ya reckon?
My setup is
I used Seans needles (stage 7?)
Put in the air correctors
157.5 mains
STD springs
Idle screws 3.25 turns out
V-boost programmed to start opening just before 4000RPM
Seans airbox lid
Marks exhaust 4 into 2
The main problem is it stumbles when trying to cruise below 4000. If the needle is just past 4000 it's fine, and accepts WOT there without problem.
When it's stumbling, opening the throttle a bit more makes it pull OK. Just won't cruise or gently accelerate with minimal throttle.
On the freeway at 4000 in 5th it cruises, and WOT works good, no stumble. :biglaugh:
What do ya reckon?