Coffinator
Active Member
My bike runs like crap while cruising, when I have the clip in the fourth slot from the blunt side of the needle. If I move it to the fifth, it's almost good, but I still get annoying stumbling when going slightly downhill/cruising. I have 165 DJ mains installed, and a stage 7 kit.
Is it not a bit much to have to use the fifth slot for achiveing a somewhat smooth operation? I feel like I'm running it too rich that way..
I've taken the carbs apart, and the pilot jets are not clogged. What else can I look at to achieve a smooth cruising engine? Does the float setting affect cruising much?
The bike runs fine under acceleration, and if I whack the throttle in first gear, it does leave a nice black stripe on the road..
I've synced it, and played around with the a/f screws without much luck..
Is it not a bit much to have to use the fifth slot for achiveing a somewhat smooth operation? I feel like I'm running it too rich that way..
I've taken the carbs apart, and the pilot jets are not clogged. What else can I look at to achieve a smooth cruising engine? Does the float setting affect cruising much?
The bike runs fine under acceleration, and if I whack the throttle in first gear, it does leave a nice black stripe on the road..
I've synced it, and played around with the a/f screws without much luck..