Hi all, Bill Denton here, retread newbie. Had a '97 about 10 years ago, sold it but now have a '99 that I'm working on. I have a question about proper placement of o-ring #33 on the needle jet #34. In the sticky called Carb rebuild parts 1-6, the o-ring is being placed onto the needle jet on the bowl side of the carb body so that it sits between the body and the jet block. However, on my carbs the orings were placed onto the needle jet on the throat side of the carb body, sandwiched between the body and the upper lip of the needle jet. Now, I know that at least one po has been into these carbs, and there were several issues that I needed to repair, so I can't be certain that the placement of the orings that I found upon disassembly were correct or not. So, I'm looking for verification as to where these o-rings should "actually" be placed, i.e. where mine were found or where the author of the carb rebuild sticky placed his. Pls advise, tks.