Patrick78
Well-Known Member
I got my HID kit from DDM Tuning installed today but I have some issues. First I just wanted to confirm that they sent me the right kit in the first place. The bulb fits in the housing fine, no issues there. But the section of the wiring harness that has the relay attached to it has a long and short section of wiring that goes to the ballasts. According to the instructions I downloaded from the site you mount this relay close to the first ballast for the short wire section and then the long section is supposed to go over to the other headlight (for a car) and plug into the ballast for that side. Did anyone else's kit come like this or did they send me a car kit and not a bike kit?
The other issue is the high beam doesn't work. I flip the switch to highs and it shuts off. Not sure what the issue is here. I went back and checked all the wire connections again and I'm sure that everything is plugged up correctly. They do a pretty good job of making it so you can't cross plug wires up so I'm pretty sure thats right. Did anyone have any issue with their high beams? Do they work?
Lastly did you hide the ballast under the scoop on the clutch lever side of the bike? Thats were I put it but they put such a short ground wire on it I'm not sure I picked a good enough bolt. Let me know what you all used for a ground location.
The other issue is the high beam doesn't work. I flip the switch to highs and it shuts off. Not sure what the issue is here. I went back and checked all the wire connections again and I'm sure that everything is plugged up correctly. They do a pretty good job of making it so you can't cross plug wires up so I'm pretty sure thats right. Did anyone have any issue with their high beams? Do they work?
Lastly did you hide the ballast under the scoop on the clutch lever side of the bike? Thats were I put it but they put such a short ground wire on it I'm not sure I picked a good enough bolt. Let me know what you all used for a ground location.